Home > Well Pump > Well Pump Not Working After Freeze

Well Pump Not Working After Freeze

I have turned it off to diagnose. I don't know how other areas do it, but Michigan has a database anyone can access: http://www.deq.state.mi.us/well-logs/ so you can research any area you're interested in. If it's going to get real cold. So I cleaned it up and the pump now works. weblink

I've been without water for almost a week. Assuming pump needs replaced, what's a reasonable cost? Tie it in place with string or yarn and turn it on at it's highest setting. at least I had filled up all the water for the horses yesterday. directory

Reply: David, It sounds as if your well recovery rate has been slowing for some time. The lines there did feel frozen as you could hear and feel the ice in the pipes so I began using a hair dryer to warm these pipes. Even though you thawed out the switch you may be frozen else where. The lines came close to freezing off at some point in the past, because one part of them is swelled like an overboiled hotdog (been that way for many years.) When

Question: well is running out of water (Aug 12, 2014) Jeb Bassett said: Our well seems to be running out of water. Check for a debris-clogged pressure switch. With advance notice for hurricanes and ice storms, we do additional prep that may be enough to tide us over until the power is restored or setup to manually draw water We've still got at least a week of sub-freezing temperatures so hopefully this will keep my pipes safe.

A freeze anywhere in your water lines will shut down the whole things, so make sure every exposed pipe or faucet is insulated. If you have access to 110 power in both of those areas, (or can get it there by some safe means) try this. Do I Nd new hot water heater? You can only upload a photo or a video.

Water Pump Preservation or Mothballing or Taking out of & Returning to Service Question: How to preserve or mothball a submersible well pump for later use What needs to be done One under the mobile and one in the well? Is it normal? I've been frozen for days and weeks!

  1. Powered by vBulletin™ Version 4.2.3 Copyright © 2016 vBulletin Solutions, Inc.
  2. Any idea of what I can do? - Arthur I live in a mobile home with a point well system (2").
  3. I would've expected this to be more likely overnight.
  4. Then back on after 10-15 seconds.

This doesn't fit with what I am reading on your page. http://www.chronofhorse.com/forum/archive/index.php/t-186778.html Any suggestions? (Aug 14, 2014) Anonymous said: We'll is new insuffient water flow. vBulletin v3.8.4, Copyright ©2000-2016, Jelsoft Enterprises Ltd. But if I by-pass the pressure switch, the pump works perfectly, but will not stop of course.

You’ll need to measure the length of the pipes that are exposed (out of the ground) so you can insulate them. http://wiiemulator.net/well-pump/water-pump-no-pressure.html I bought an 86 gallon pressure tank from Menard's and I also bought another Square D 30/50 pressure switch to replace the same model that was already installed. Short cycling pumps can cause damage to the pressure switch or to the pump itself. Note: the discussion of diagnosis and cure of flickering or dimming lights occurring when the pump motor turns on has been moved to FLICKERING LIGHT DIAGNOSIS Question: left water on, is

Do this few times and then live the drain from the hot water tank completely open to ensure the trapped air is out after about 10 min. No flouride or chlorine. I think it's just frozen at the pump that comes out of the wall, but not underground. http://wiiemulator.net/well-pump/how-to-tell-if-well-pump-is-bad.html Could also be a leak or hole in the well casing Or a leak in the well piping anywhere between house and bottom of the well Or nearby drilling or blasting

I reset the breaker and it has been fine. The first evidence of the water system, from the shack to the mobile is an access panel to the water heater on the exterior of the mobile, just below the panel After much struggling and attempting to do it myself I learned that for these big jobs on the home I needed to hire a professional.

Don't run the pump dry as it may be damage.

My florescent light fixtures aren't working.? 16 vs 10yr old home? Turn the pump off right away to (maybe) avoid damaging it. I'd like to not have to use the heater, but I understand that if the system freezes up I risk damaging my submersible pump, a $3,000 repair. Or is this something I'll need a pro for?

After several hours of this and no luck I followed the pipe to see if there was more frozen areas. We objected saying, first of all, we're in a drought, and secondly, the well is used only for outside irrigation of our garden. Time to update your mattress? this content Be sure to make part of your planning backup plans that include alternative sources of water and ways to make it safe for use.

I Managed to get things running in 5 minutes or so. Do you drive over the line?? keydl08-19-2010, 10:08 AMOne of the more interesting places that I lived we wintered 2000 head of feeders. Lauren In the More Reading links just above you'll want to read the diagnostics in the article titled WATER PUMP WONT STOP RUNNING Question: pump runs but no water (June 23,

That said, there's one more point that I'd like to make. First of all the well is extremely deep. 986 ft if I'm not mistaken which is ridiculous for this area, just my bad luck. Then off after 5-10 seconds. After checking that your pressure tank has a proper air charge, if the problem remains let us know and we'll take it from there.

James ozzymanii · 8 years ago 0 Thumbs up 0 Thumbs down Comment Add a comment Submit · just now Report Abuse You didn't say if this is a deep or Is there any point in insulating it while it is still possibly frozen (i.e. but then after not using the water, the same problem above happens MenuHomeEmergencyWater HeatersWater Heater ServicesCharlotte Tankless Water HeatersSpecial Offer Grundfos Hot Water Recirculation SystemLeak DetectionLeak Detection ServicesGas Line Service/Gas Can you thaw out a frozen hot water heater?

I turned off the water and when I returned to the cabin again it was the same except this time after three of the above cycles the pressure dropped to zero